Walker has no power

[DennisW]

I went to start up my walkers today after their winter rest. One was fine. The other has completely no power. I gave it a charged battery- and nothing. No alarm, click, nothing.
Is there a fuse or something that could have failed? I had it winterized at the dealers in fall, and I ran it dry with no problems. Can't find anything disconnected either. Thanks for any help.

[fixer67]

Make and model? The MTGHS has a fuse at the starter and a ciruit breaker and a fuse at the battery. The question is what blow the fuse in the first place. Are the battery post clean? You could have a bad ground. the ground wire where it mounts to the frame beside the battery may need to be removed and cleaned, seen that happen many a time.

[DennisW]

Thanks, yeah it's MTGHS. The terminals seem clean but I'll make sure. I will find the fuses- I did find the circuit breaker- can you tell me what to do with it? Wasn't sure where to go with that. Thanks.

[DennisW]

Fixer if you're still there, I removed the circuit breaker but couldn't see a problem, not sure what to look for. I also don't see any fuses. What do they look like? Thanks if you can help!

[jimslawns]

Saftey Switch in seat? You can jumper around it to test it, and if that is the problem you can get a replacement. Also there is a relay with two posts on it that could be your problem.

[fixer67]

Fixer if you're still there, I removed the circuit breaker but couldn't see a problem, not sure what to look for. I also don't see any fuses. What do they look like? Thanks if you can help!

The fuses are ATC type. They are about a 1/4 inch thick and 3/4 in long. Below is a enlarged photo of what one looks like. The come in different colors, each color for each amp rating.

[gene gls]

I have had a problem with the safty switch for the PTO lever. The little pushbutton sticks and/or the wire plugin connection comes loose.

Gene

[BCSteel]

Could be the ignition too. I had to replace my key ignition because of the same problem.