PDA

View Full Version : jd 400 oil drain fitting question


rbig
06-05-2005, 05:29 PM
The JD 400s seem to have two different designs for the fittings where you drain the oil.

One type is definitely a cap, and it has to be screwed completely off.

One I found today that I haven't worked with before is a fitting with a T bar on the outer face of a cap. I was able to turn the T bar fitting enough to get oil dribbling out.

Given the tight clearances and the fact this fitting is "buried" behind a hole in the frame, I'm not sure I'd ever get it back on again if I took it off.

My question is: do I need to take it off to drain the oil reasonably quickly? Is there a stop of some kind to help keep me from inadvertently running it all the way off? Is there a downward looking hole that turning the T bar outward clears progressively, so that more fluid will come out the more turns I give the T bar?

If for some reason I have to run the t bar cap all the way off to get a reasonably fast fluid drain, I may be in trouble with getting it back on.

Anyone been there done this that can give me some help on this?