PDA

View Full Version : Suggestions?


waldo98998
02-03-2006, 04:23 PM
I just finished setting up my new Husg 36" walk behind mower. It will not start! Any suggestions, things to check?

Trinity Lawn Care, LLC
02-03-2006, 04:31 PM
I am not asking this to be sarcastic, but is there gas in it and is the gas turned on?

Rayray
02-03-2006, 04:47 PM
Have u checked the kill switches?

Wells
02-03-2006, 04:54 PM
I bought an Aerator once and had the same problem, it ended being the spark plug was mis-gapped. I would also check for a spark from the plug wire in order to rule out a faulty switch and then try a shot of starter fluid, this time of year when things are cold they have a hard time starting anyways.

TURFLORD
02-03-2006, 05:17 PM
Choke it and pull the cord several times. Then pull the plug. If its dry, no gas. If its wet, no spark. pull the fuel line at the carb and see what you get. Check all kill switches and low oil cut off if you have one. Hopefully you putting it together didn't void any warranties. Good luck.

METRO 36
02-03-2006, 05:25 PM
i started my exmark abought a week ago to show someone how fast it run's,width of cut,safety feature's,ease of maintaince etc. i pulled on it for 5 min before i pulled the plug to se if it was fouled,the spark plug was dry that's when i realised i forgot to turn on the fuel switch. oops

justanotherlawnguy
02-03-2006, 05:58 PM
If it is new, take it back to the dealer........

KeystoneLawn&Landscaping
02-03-2006, 08:54 PM
I was wondering why the dealer didnt have it set up and running when you picked it up?...it is new right?

Collin
02-03-2006, 10:40 PM
Safety switch might be stuck:)

Brianslawn
02-03-2006, 10:53 PM
take it back to lowes.

jeffex
02-04-2006, 06:14 AM
If I run my WB out of gas it has to be primmed or it will not restart. It could be the same thing for you . I think the dealer should have set it up but you can just get some starter spray and shoot it in the carb. The fuel line should have a clear filter in line. Is it full of gas? Is the valve OPEN to let gas flow? sometimes you have to loosen the fuel line and let some gas run out to get rid of air blocking the fuel flow. Check blade engaged switch.

McClain
02-04-2006, 06:29 AM
its a Husg take it back..........................