Help

[pcs]

I'm trying to take my blades off of my walker ghs deck. I can't get them off. Do you have to go the oppisite way because one of the blades go the oppisite way?

[cantoo]

No they are normal, make sure you use a wooden block to hold the blade from turning. It will make it easier to get some leverage, next time put some grease on the threads.

[awm]

i highly recommend the 12 volt impact wrench .
you can get them on ebay for 39.95 most of the time.
i also use a jump starter to plug into but the cord on these are pretty long(PLUGS INTO CIG LIGHTER)
dont worry it is strong enough to take a rusted
nut off.luck to you

[captdevo]

turn left to loosen, right to tighten

do not over tighten when you are replacing.

Torque to 60ft-lbs. only. or you will defeat the purpose of the shear bolts.

[Fantasy Lawns]

this is when an impact wrench really helps .....when your by your self ....no need to block the blades ....be sure to put a few drops of oil on the nut or threads when putting it back on .....just helps in removal