PDA

View Full Version : Carb Problems


burlap
09-12-2006, 08:48 PM
17 hp kawasaki JD F525
Problem: Won't start w/o a prime in air cleaner or unless it's just been running.
Pumping gas at carb.
Solenoid works from battery and I can feel it click when I turn the key.
I ran a wire through the main nozzle and the intake nozzle-needle orfice.
What else should I check?

fly-4-fun
09-12-2006, 08:57 PM
Be sure that the choke butterfly is closing all the way in the throat of the carb.They sometimes get to where they are not all the way shut when the control cable is set to "Choke".

lawnmaniac883
09-12-2006, 10:27 PM
If you have cleaned the carb fully then it will start with a gas prime and run once started?

Check your carb vent, should come out of the top may have a length of plastic tubing on it. Have you adjusted your valves? How many hours on the unit?

burlap
09-12-2006, 10:51 PM
I did check the choke and it looked closed to me.
I'm rebuilding this from several mowers so there is some time on the unit and the carb. The valves were adjusted. It seemed to idle good when it was running. I will check the vent tomorrow. Would the vent work okay once it's going but be a problem while starting? Thanks again.

Restrorob
09-12-2006, 11:45 PM
Would the vent work okay once it's going but be a problem while starting?

Not likely.....It would be the opposite You need to make sure the choke is closing ALL the way as stated already.