PDA

View Full Version : Yes! Another RBG question


Huck
06-23-2001, 11:04 PM
When using these grinders, do you find that holding the blade at an angle to the wheel instead of 90 degrees, creates a better concave look instead of a squared off corner where you stop grinding? thanks,huck :)

Eric ELM
06-24-2001, 12:04 AM
I always hold the blade flat on the table when sharpening. This is the way this should be done to be consistant with the angles. Adjust the motor and wheel up or down to get the correct angle to start with.

cp
06-24-2001, 01:07 PM
I wish I could afford one.

I'm using a Makita 4 1/2" hand held and I am not very good at it.