View Full Version : Need help with SCAG deck/blade wiring harness

Orkin Yards
01-28-2007, 01:10 PM
Can someone give me a picture of this on their mower so I can see where the wires are suppose to go - or if anyone knows which wires go to which I would appreciate a description....

thanks in advance

01-28-2007, 06:26 PM
which scag mower is that on, I looked at my tiger cub and it doesnt look like that, I have a walkbehind too but couldnt get to the back of the shed to see it tonight


Orkin Yards
01-31-2007, 01:08 PM
it is a 36" belt drive walk behind - hope you can help....

Orkin Yards
02-02-2007, 02:20 AM
anyone out there?

02-02-2007, 07:38 AM
I have the same mower I'll check this mornin and will get back w/ you this evening

Orkin Yards
02-02-2007, 09:25 AM

02-02-2007, 12:49 PM
I ookead my 36 hydro with the kawi engine. nothing like that onmy machine.

looks like the voltage regulator/rectifier you have a Kohler engine?

Orkin Yards
02-03-2007, 09:35 PM
no it is a 12.5 kaw - anyone else out there that can help me?

02-03-2007, 10:56 PM
You can go here; http://www.scag.com/OpManuals/SW/SWOPMANTOC.html

With your model and serial numbers down-load the operator's/parts manual. Toward the end is a diagram, It doesn't show wire colors but shows where each wire goes.

02-04-2007, 07:00 AM
orkin, Mine was diffrent too !

Orkin Yards
02-05-2007, 09:11 AM
I have the owners manual, but sure can't figure out what the wiring diagram is trying to say...

02-05-2007, 09:33 AM
can you scan it in or give your SN and I'll download the one form scag web site.

When I was learning engineering way back I took a few electrical engineering courses.