View Full Version : how to remove and replace a hydro pump
03-17-2007, 02:43 PM
Does anyone have some advice on changing out a hydraulic pump on a zero turn yazoo kees pump number bdp-10L-117P. Can a semi novice do it? Any step by step instructions out there? Any suggestions would be appreciated.
03-17-2007, 04:18 PM
Why are you replacing it? If it's chewed up you'll need to flush the lines and tank. Install a new filter. As for replacing it. Just take several digital pictures of it for reassembly.
03-17-2007, 06:20 PM
have a yazoo kees with 2 pumps--one for left and one for right. The one on the right will not work--makes loud chirping noise and will not go forward or reverse. Had reverse for a while then no forward. Landscaper said the pump was probably out. Tried changing fluid and bleeding, etc. No leaks. Someone else said possibly wheel motor--This is a 10 year old model with a lot use. Several people agreed with hydraulic pump. So I guess I start there.
03-17-2007, 10:01 PM
Have you taken the pulley off to see if it was spinning on the shaft? Maybe the key sheared?
03-18-2007, 12:29 AM
no--but I will thanks for the tip
vBulletin® v3.8.6, Copyright ©2000-2016, Jelsoft Enterprises Ltd.