PDA

View Full Version : updare/question- on gas in hydro problem..


mowisme
04-25-2007, 08:42 PM
hi folks. The contaminated gas/oil mix is drained as best as I can get. After wheel motor hoses were disconnected and hanging down..I also turned the wheels a little to pump them out. I also took filter off and drained it and put back on ( will put new one on after I get it running a bit and get the new oil circulating) I put 6 quarts of Castro 20-50wt oil in tank. I think I'm ready to fire it up and get oil flowing. Then I'll drain again at the wheels and fill up tank. at that point I will also put new filter on..BUT, How do I get the air out of system? Is there a specific way to do this if all hydro is changed out, and that air is now in system? thanks again for your help Gene

Restrorob
04-25-2007, 08:53 PM
Most common is put the rear on jack stands, Fire it off and run at-least half throttle then move both levers full forward then full reverse slowly eight or so times. Check oil level again then take it for a spin and see how it acts.