PDA

View Full Version : Honda HRX Blade Sharpening


antelope113
04-30-2007, 12:23 AM
I've been looking at these blades and it's going to be quite difficult to sharpen, anyone have input on this? Besides hand sharpening?
http://www.hondapowerequipment.com/hrx/

pugs
04-30-2007, 12:51 PM
Unless they have changed something the hondas usually use 2 blades. They are seperate. So its just like any other blade to sharpen.

I have seen some really funky ones that have 4 blades on a single piece of steel. I think I told him to take that POS back where he bought it or get a new blade.

khouse
04-30-2007, 04:02 PM
Yes, I'm getting tired of all the blade configurations. Seems to me all it does is weaken the already thin blades. I think the old standard strait high lift blades are the best.

antelope113
04-30-2007, 11:18 PM
Yeah, this one is 2 pieces off one steel... seems pointless to me, but I never ran into a blade like these before. Guess we'll see where it goes..

Mark in MD
05-01-2007, 10:59 AM
What a crock. That system is no better than the other double blade system we already know about. And it might be worse.

Jay74
05-03-2007, 11:17 PM
It's the same twin blade setup. Unbolt the blades, sharpen, balance, and install the blades.