View Full Version : Changing Blades
06-05-2007, 08:49 PM
Ok, I know how to change them
the question is how do i get the mower high enough or do u just raise it as high as i can
i have a 36" snapper pro, residential use at this point
MOW PRO LAWN SERVICE
06-05-2007, 08:54 PM
I use a jungle jack,they are expensive but they are used every day at the shop.
06-05-2007, 09:14 PM
On a unit that small you should be able to grab the front of the deck and lift it high enough to slide a jack stand under with your foot.
Or set the jack stand in front of the unit and push down on the handle bar and roll it onto the stand.
Or drive the front wheels up on some car ramps.
06-05-2007, 10:02 PM
thanks you for the suggestions
Mark in MD
06-06-2007, 09:31 AM
I'm not familiar with the Snapper Pro, but with my machines (Bobcats 32, 36, 48) with Kaw engines, I just grab them from the left side and flip them over onto their side 90 degrees. Carb up.
vBulletin® v3.8.6, Copyright ©2000-2015, Jelsoft Enterprises Ltd.