PDA

View Full Version : Bearing removal


anubis7273
06-17-2007, 08:40 AM
OK, well I have another question. Does anyony know how to remove the bearings on the blade shaft for a Bobcat 48" Deck? I have tried a bearing tool from Craftsman and it bent it right away. Is this something that I should remove from the top of the deck? Thanks, Kevin

Mark in MD
06-18-2007, 08:31 AM
I'm not sure from your post whether you want to remove the ball bearings, or the entire spindle.

When the spindles wear out on my Bob-Cat, I just replace the entire spindle. You'll need a pulley puller first.

I've read that Bob-Cat spindles are mounted with lock-tite at the factory. If you heat the bolts, it should loosen the lock-tite.