PDA

View Full Version : Exmark striping kit 60"


turbo5560
07-03-2007, 10:47 PM
I just bought a striping kit for my 60" Exmark. The directions stated to set it a 1/2 inch off the ground from my normal mowing height. I usually mow at about 3.5". I tried it out tonight and didn't have the best results. It did a good job, but not much better then it did without the kit on it. Any help? Maybe better if I cut the grass higher?

TNT LawnCare Inc.
07-04-2007, 12:36 PM
Are you able to spin the roller bye hand at 3.5 inches?

turbo5560
07-04-2007, 02:25 PM
Spin it while the deck is on the ground? No. Does that make a difference? It does roll as it goes across the ground.

TNT LawnCare Inc.
07-05-2007, 09:05 AM
Try a few different positions maybe 1 more hole downward or up.