PDA

View Full Version : walker solenoid


bligh61
07-04-2007, 08:55 AM
is the solenoid seperate from the starter on the 20hp kohler. can just it be replaced without lifting engine?

carcrz
07-04-2007, 10:49 AM
Last time I was at the shop, they said that the older models were joined & newer models were separate. When I needed one replaced, I went ahead & put a newer version on it.

Restrorob
07-04-2007, 11:15 AM
is the solenoid seperate from the starter on the 20hp kohler.

It depends on what model and spec. engine you have ?

bligh61
07-04-2007, 01:25 PM
MT 20 hp 2001 ghs

bligh61
07-04-2007, 01:26 PM
MT ch20 hp 2001 ghs

Restrorob
07-04-2007, 02:26 PM
Ya gotta make up your mind, MT= Magnum Twin/ CH= Command Horizontal. There is a spec. number below the engine model number also.

bligh61
07-04-2007, 03:14 PM
MT was the walker model, sorry, ch 20 for the kohler, i will look up the spec on the eng and get back to you. thanks

Restrorob
07-04-2007, 03:54 PM
The solenoid is mounted on the starter, Looks like that one may be fun to replace with it down inside that frame.

I have a starter problem with my unit in my avatar, The drive is sticking. But, Have to remove the whole body then the engine out of the frame. I've been un-sticking it with a long screw driver for two years now. :dizzy:

tomo
07-04-2007, 05:38 PM
hello, remove blower from underside of machine . This leaves the starter mtr exposed enough for easy removal. If starter is the original nippon type a suggestion would be to replace with the Delco unit .

tomo .

Jay74
07-05-2007, 11:23 PM
Remove the motor... by far the easiest route. 20 minutes to remove & 20 to install. Piece of cake.

BTW... I hate Walker mowers.