PDA

View Full Version : Watts H560 PRVs?


irrig8r
11-07-2007, 08:05 PM
Anybody using these for drip systems? I ran across a couple on a job that must have been installed at least 15 years ago. One is not working, over restricting pressure to under 10 PSI. Not sure if I can still get them or maybe try the repair kit.

http://www.watts.com/prod_images/hi-res/H560G.jpg

The picture is larger than life size. That's 3/4" hose thread. The brass hose to pipe thread adapters installed with it are in fine shape.

Mike Leary
11-07-2007, 08:10 PM
Netafim PRV.

FIMCO-MEISTER
11-07-2007, 08:15 PM
Never seen those. Like the looks of them. Must be the brass.

CAPT Stream Rotar
11-07-2007, 08:53 PM
Netafim PRV.

That is the only set up we use...They aren't that much $$$...

never had any problems with them yet.

irrig8r
11-07-2007, 09:28 PM
Normally I use a Wilkins BR4 on the main line of a manifold for a group of drip valves, or if my incoming pressure is low enough, I use a fixed plastic regulator.

I don't know if my local suppliers carry this one, but I do like the fact it has a gauge built in, and it's adjustable.

Mike Leary
11-07-2007, 09:31 PM
Who cares what the pressure is if you're using Netafim?

irrig8r
11-07-2007, 10:26 PM
But I'm not using Netafim.... though I fully defend your right to do so...