PDA

View Full Version : Dodge 3500 dually bed bed height


brucec32
12-20-2007, 03:18 PM
I'm toying with the idea of getting a regular cab dually 3500 with the 8' bed and using a full width ramp (removing the tailgate) in lieu of towing a trailer around all day. I have had a few access and parking problems with trailers and a shorter compact setup might be best for my 100% maintenance (90% mowing) operation.

I felt the added stability of the dual rear wheels and larger weight capacity would make it a safer alternative to a 1500 series type pickup. stripper Reg cabs are also fairly cheap these days. The resale picture also seems attractive on the HD trucks from my limited research.

I've used the ramp in the past (load is carried by the trailer hitch) with no problems loading unloading, it's just like driving up a trailer ramp, only a little steeper.

One limitation however is how steep the approach angle is when loading a ZTR. To determine that I need to know how high off the ground the vehicle's bed is (w/o tailgate preferably, since they ride butt high) and figure out if my 8' ramp system is sufficiently long that it doesn't hang up the mower deck at the peak or drag the tail at the bottom of the ramp.

I assume the heavier springed trucks sit higher, (this would be 2wd) but can't confirm it and haven't found the spec online yet.

Also, does anyone know what a non diesel (hemi) powered version would get for fuel economy empty, loaded, and towing?

Thanks.

Accu-cut Lawn Care
12-20-2007, 03:28 PM
You will need way more than 8 feet of ramp, I figure. I have a dovetail on my 1500 and the 9 foot ramp is just right. I'm not sure the exact height of the dovetail; but, I'll measure it for you soon. I'll guess that a drw bed is a little bit higher than my set up. I have a non hemi 4.7 in my dodge and I get about 15 mpgs loaded... 17 if I really baby it. In a 3500, it's probably a bit less. Maybe 13 empty and 12 loaded.

mag360
12-20-2007, 10:44 PM
you can lower the rear of the truck (level it) and use airbags to maintain the ride height loaded.

Lawnworks
12-20-2007, 11:07 PM
or buy an isuzu and be done with it.

tthomass
12-20-2007, 11:44 PM
3500........i'd say 9-10mpg

If you go this route scrap the bed and have a flatbed (say 8'x12') w/ dove installed. Do it right the first time.

Accu-cut Lawn Care
12-20-2007, 11:48 PM
I second this. You'll gain a lot of bed space, too.

tthomass
12-21-2007, 12:03 AM
I've been thinking about it for my 2500HD........haven't decided and I'm different use (don't mow).....so I'm weighing in different ideas.

Accu-cut Lawn Care
12-21-2007, 12:11 AM
I love the looks of your new hd. I'd wait to get a couple of scratches on her before adding a bed... Then go aluminum.

tthomass
12-21-2007, 12:17 AM
haha.........NOOOOOOOOOO NOOOOOOOOOO NOOOOOOOOOOOOOO.........not the new one! That is mine, ALL mine.

I'm talking about my '02.

Accu-cut Lawn Care
12-21-2007, 12:23 AM
An '02... Flatbed that old girl! Add underdeck boxes and they, alone, will give you as much storage as your stock bed.

tthomass
12-21-2007, 12:32 AM
Mind posting up a pic of your truck?

Accu-cut Lawn Care
12-21-2007, 12:41 AM
Look in the pictures forum under Dodge dovetail completed. It's not too far down.

Accu-cut Lawn Care
12-21-2007, 12:42 AM
http://www.lawnsite.com/showthread.php?t=174319