PDA

View Full Version : Rebuilt my Kohler somthings not right


columbiaplower
04-29-2008, 05:18 AM
i just rebuilt my kohler cv20s and i put it all back together tonight and when i start it up with the throttle at idle, the motor immediately start up at super high rpms, moving the throttle up and down does nothing? Im guessing this is a gov issue but im not sure. any help would be great.

S DIAMOND
04-29-2008, 11:01 AM
Start off with performing a static governor adjustment. It's on page 5.30 of your service manual.:walking:

columbiaplower
04-29-2008, 11:54 AM
thanks ill give that a try

Mike7468
04-29-2008, 03:31 PM
Same issue with my CV23. Ready to just tear it down and rebuild it again.

VegetiveSteam
04-30-2008, 01:36 AM
Did you take the gov gear off it's shaft and not replace it with a new one? Once you take them off their shaft they can't be reused. They have to be replaced. If you didn't touch the gov gear then yes do a static adjustment. To do that simply loosen the pinch bolt on the gov. lever where it clamps on to the gov. shaft. Move the gov. lever as far as it will go to open the throttle all the way. Then turn the gov shaft as far as it will go in the same direction and tighten the pinch bolt and you are done.