View Full Version : Can't remove the tines on Honda FRC-800 Tiller
07-31-2008, 11:19 PM
I am at a loss as to how to get the right tine assembly off the drive shaft of my tiller. I had minimal trouble removing the left side assembly, but after removing the bolts I can't get the assembly off the shaft. Any ideas?
08-03-2008, 10:26 AM
How old is the tiller. I don't know honda tillers, but with my ariens and gilson, I had to use penetrating oil, heat, long punch, and a hammer to beat it off the shaft. On my gilson, I was trying to replace the brass bushings, so all I had to do was get one side off and slide the shaft out of the housing.
Are you just trying to remove the tines, or the whole mounting assembly that slides on the shaft??
vBulletin® v3.8.6, Copyright ©2000-2014, Jelsoft Enterprises Ltd.