Starting problems with Exmark/Kaw

[I.M. Green]

I just picked up an Exmark Metro 36" with a Kaw 12.5 HP. It has been sitting for 2-3 years. It started once after pulling and pulling and ran decent. I have rebuilt the carb and now there doesn't seem to be any spark. So from what I know it could either be the coil or the flywheel/magnet. Is there any other options that it could be and how do I check and narrow down what is before I go spending money on something? Is there a way to check the coil with my basic tools? Yes I did put a spark plug in it...

[Phil G]

I just picked up an Exmark Metro 36" with a Kaw 12.5 HP. It has been sitting for 2-3 years. It started once after pulling and pulling and ran decent. I have rebuilt the carb and now there doesn't seem to be any spark. So from what I know it could either be the coil or the flywheel/magnet. Is there any other options that it could be and how do I check and narrow down what is before I go spending money on something? Is there a way to check the coil with my basic tools? Yes I did put a spark plug in it...

Have you checked all the safety switches are in neutral? Blade clutch etc. Check earth leads etc Then go onto coil testing.


Good luck, Phil

[MowerMedic77]

You would have to post a Spec# to be sure but your engine may have a two piece ignition system #1 igniter #2 ignition coil. You can look on the side of the block that the dipstick is on and see if you can find a small silver box with one male spade connector(see pic)
http://www.lawnsite.com/attachment.php?attachmentid=111436&d=1213201605

If you scroll down in this thread, Restrorob has posted the test procedures for the igniter.
http://www.lawnsite.com/showthread.php?t=240224&highlight=ignitor+test&page=2

[I.M. Green]

it was simple. The shift lever was off and apparently could not go into nuetral, so once I got it right and into neutral it was all good and she fired right up! Thanks for the advice though...