PDA

View Full Version : 04 toro 36 wb problem


allfiremencutgrass
10-24-2008, 05:14 PM
Upon starting my Kohler 15 command engine on my 04 proline wb belt drive w 150 hrs..I let it warm up a min or so and pull the clutch button and motor wants to bog down and die I sometimes it takes a few times to get it going..Any thoughts?

CLARK LAWN
10-24-2008, 06:03 PM
motor needs to warm up a little more your putting to much of a load on it with everything beong cold

allfiremencutgrass
10-24-2008, 06:14 PM
Ok thats cool thanks for the reply...I thgt I had been but Ill give it some additional minutes.thanks

Grits
10-24-2008, 06:26 PM
Where is the throttle positioned when you engage the clutch?

allfiremencutgrass
10-24-2008, 06:28 PM
always started it wide open.

Grits
10-24-2008, 06:36 PM
always started it wide open.

So you have had this mower for a while and it just started doing this? Is this the first cooler weather you have had with this mower?

allfiremencutgrass
10-24-2008, 07:33 PM
Yea its weird it just started doing it and its not cold here 68 70 degrees nice 1300hrs...Maybe its cold maybe something is too tght but Ive done nothing but PM its been great to me???

LawnTamer
10-24-2008, 07:40 PM
Make sure the governor arm is moving, when you put the mower under strain, like engaging the blade, look to see, the governor should open up to compensate. You should see the arm(behind the carb) move. You could even have a fuel flow problem, so that when the governor does open up, more fuel can't pass through the carb. Check your air cleaner, and run some Seafoam through the carb.

allfiremencutgrass
10-24-2008, 07:42 PM
good stuff! I will tom...

lawnprosteveo
10-24-2008, 08:34 PM
motor needs to warm up a little more your putting to much of a load on it with everything beong coldDitto...my Toro wb does this when we get into colder weather...I just let it run for a couple of minutes before I try to cut with it.

dishboy
10-25-2008, 10:06 AM
If your air cleaner is clean and you are getting enough air I would guess you are running lean, clean out the carb air /fuel passages with carb cleaner and compressed air.