Homemade OCDC

[JPAC]

I made this from some scrap around the shop, cost me about $25 in supplies.
Let me know what you think! Thanks,
John

Sorry about the picture quality, taken with cell phone.

[DLAWNS]

Looks good to me! I need to get me one of them!

[Lawn Freak]

Looks good! Good fabrication.

[JPAC]

Thanks Guys,

I have access to a full machine shop at work, and my boss gave me the steel all I had to pay for was the u-joint and coupler.

John

[Lawn Freak]

Good choice on the mower too. :D

[JPAC]

It's a 2005 Gravely Pro1548 I got for $900.00 with the sulky. It has 243 hours, it was a 4 hour drive there and back to pick it up and I couldn't pass up the deal.

[Lakewlc]

nice job!!

[Jmill88]

I think I am going to try and make one of those. Where did you get the u-joint and coupler?

[Chris B.]

What is the point of an OCDC?

[lifetree]

It's a 2005 Gravely Pro1548 I got for $900.00 with the sulky. It has 243 hours, it was a 4 hour drive there and back to pick it up and I couldn't pass up the deal.

Even considering the drive, it sounds like a good deal !!

[B Erler]

How exactly did u make that? i have the Gravely 1336 pro and ive been thinkin bout building one of those for my mower but i cant really figure it out...

[JPAC]

I got the u-joint and coupler from McMaster-Carr. I think I paid $25 for all the supplies.

www.mcmaster.com (Low-Speed Pin-and-Block U-Joints)