PDA

View Full Version : Hustler Flex forks on Exmark


michaelee2
03-14-2009, 04:11 PM
Have a 46" Exmark Hp and was wondering if the Hustler flex forks would fit it or has anyone tried this. Really like the looks of the flex forks and would like to have them. :confused:

djagusch
03-14-2009, 05:41 PM
If you own a welder it can be put on any ZTR. I know they don't bolt to a Scag, not sure on the Exmark. But anyone could cut off the shaft and weld it on.

Grassman6
03-15-2009, 12:15 AM
Used 'em....broke 'em...bought a Ferris. However, the welding action is also a good plan. When welding the new Flex-Fork to your castor spindle plan to extend the attachment one inch, then on the rear of the machine add the next size larger drive tire thus allowing a slightly lower tire pressure and the ride improves significantly. Don't forget to check/adjust your deck pitch.