PDA

View Full Version : Which Stihl saw should I buy?


fool32696
03-20-2009, 12:04 PM
I'll be using the saw for cutting expansion joints in concrete and doing some light concrete demo. My dad had Stihl TS350s for years and loved them. I've been looking at a used TS400 (http://orlando.craigslist.org/tls/1077424896.html) and I'm pretty sure I priced a new TS410 at $859. I feel like these saws will do the job, but should I go bigger? Do I need to go with the 410 over the 400? Also, what will I expect to pay for a decent diamond blade?

soopa
03-20-2009, 12:40 PM
The 400's are dogs when it comes to concrete demo, IMO. You're much better off with a walk behind or a heavier / more powerful hand-held like a 700 or 800.

For what you're doing, save your back and spend the money... go with a walk behind. They're purpose built for that job.

Stick with the hand-held if you're primarily cutting pavers or block.

NewHorizon's Land
03-20-2009, 02:49 PM
For a good diamond blade you could expect to pay up to $300.

JRSlawn
03-20-2009, 03:17 PM
There are good diamond blades out there for around $75 but there are some shity blades out there too. I like my 400 keep the filter clean and you will like it I want to get a new 420. I bought 12 blades and a saw brand new for 1200

AllHardscaping
03-21-2009, 03:53 PM
TS 400s ar egreat for pavers but when you sink most of the blade into concrete it doesnt have the balls to be doing it all day. Id get a bigger one. I would stihl get handheld for the versatility but get the cart that stihl makes for their handheld saws. That way your initial cuts will be easy, standing up and when you have to cut into non flat chunks you can still do it.

soopa
03-21-2009, 05:06 PM
TS 400s ar egreat for pavers but when you sink most of the blade into concrete it doesnt have the balls to be doing it all day. Id get a bigger one. I would stihl get handheld for the versatility but get the cart that stihl makes for their handheld saws. That way your initial cuts will be easy, standing up and when you have to cut into non flat chunks you can still do it.

Good suggestion. I didn't even think about the cart... I need me one o' them!

In that case, get a TS700 & a cart.

Bru75
03-22-2009, 12:52 AM
You said "light" concrete demo. I think a ts 400 is fine for that. I've cut up some pretty big slabs with mine. It would not be the best choice for heavy demo.

BostonBull
03-22-2009, 08:12 AM
TS420, if all your doing is LIGHT demo work, i.e. a few slabs here and there. The 420 allows a 14" wheel, where the 410 is a 12". If your doing more get a 700 or 800 with cart.

fool32696
03-22-2009, 06:13 PM
I appreciate all of the input guys. I mainly do decorative concrete work and would probably only use the saw once a month. On occasion I need to remove a bad section of sidewalk or patio due to sinking, raising, or extensive cracking. I'd also use it to cut in expansion joints when we do a small pour. I usually sub out anything bigger than a couple yards. I'm thinking that for my small scale use I'd like a compact and light machine. There is a 700 with a cart for $1200 that I may look at.