PDA

View Full Version : spindle Assembly 580-d toro mower


raider450
04-21-2009, 01:58 AM
Ok! I replace the spindle assembly,because spindle shaft and pulley spindle strip at the splines(what causes this?)so I replace shaft,pulley bearings,seals pack the bearings.A week later toro returns with same problem.The only thing that I could think is that I did not install the spacer between bearing (lower blade side)and I notice when I was greasing no grease would go in the spindle assembly.Is there a preload on this assembly and how much?(little or no play)Thanks!