4.3mudder
05-29-2009, 04:50 PM
Well kept and well maintained Toro 21" Commerical 4 cycle mower. Mower is powered by a 5 horse OHV Kawasaki engine. Mower is in terrific condition and has been cleaned up. I hit a few spots with touch up piant on the sides where they get scratched easily. Unit was in my landscaping company, but was used primarily as a backup and was hardly used at all. Mainly sat in the trailer most of the time so it still has a lot of life left. Mower was never outside and was always inside out of the weather.
Engine runs flawlessly and sounds like it did when it was brand new. It does not smoke nor burn oil. Like I said, it was well maintained.
Mower was just serviced a couple of weeks ago. I no longer need it because I'm downsizing.
List of the tune up procedure.
Brand new Wix Oil Filter, Mobile 10W30 Oil, NGK Spark plug, Air filter, throttle cable, new carburetor needle, and also a new Valve cover gasket.
Fuel tank was taken off and thoroughly cleaned and also the screen inside the tank is clean
Blade was just sharpend and is ready to be used.
Flywheel was taken off and exaamined for rust on the coil and flywheel, cleaned as necessary.
This mower is ready to go and has a lot of life left ahead of it.
If you have any further questions please contact Nathan at 214 674 2551. Thanks
Engine runs flawlessly and sounds like it did when it was brand new. It does not smoke nor burn oil. Like I said, it was well maintained.
Mower was just serviced a couple of weeks ago. I no longer need it because I'm downsizing.
List of the tune up procedure.
Brand new Wix Oil Filter, Mobile 10W30 Oil, NGK Spark plug, Air filter, throttle cable, new carburetor needle, and also a new Valve cover gasket.
Fuel tank was taken off and thoroughly cleaned and also the screen inside the tank is clean
Blade was just sharpend and is ready to be used.
Flywheel was taken off and exaamined for rust on the coil and flywheel, cleaned as necessary.
This mower is ready to go and has a lot of life left ahead of it.
If you have any further questions please contact Nathan at 214 674 2551. Thanks