Tomt
06-12-2009, 09:27 AM
Hey guys, I have a pb620 that just started, or not started. Yesterday after 4 or 5 yards my blower was hard to start. If you pumped the primer many times it would start run a few seconds then die. I then changed the fuel filter, and plug, both looked fine, the plug was very light as if running lean. When pumping the primer you can hear sucking but very little gas in getting into the primer. I blew through the pickup hose and there seemed to be no problems. I took the carb and the primer off and all parts appeared to be ok.
There are no visible fuel leaks.
I have gone back to my primary 650 for now.
This is a used blower I bought of ebay but have been using for 3 month and usually starts on 1-2 pulls, and runs fine until now.:confused:
Your help will be very appreciated!
Tom..................
There are no visible fuel leaks.
I have gone back to my primary 650 for now.
This is a used blower I bought of ebay but have been using for 3 month and usually starts on 1-2 pulls, and runs fine until now.:confused:
Your help will be very appreciated!
Tom..................