View Full Version : What should you pay contract work for doing bushes/shrubs?
FORDSFUNNYFARM
06-18-2009, 10:00 PM
We are getting so far behind on our work for our customers (can be a good thing) that we are considering a young man as contract work to help us with triming bushes and shrubs. What is the going rate for contract work ? We do not want to pay by the hour, but looking at a percent.
We are responsible for dumping the clippings and we don't have any place to just get rid of them. Dumb fees are ourtageous.
Thanks!
grandview (2006)
06-18-2009, 10:07 PM
I think your in a catch-22. If you pay him by the hour he may try and milk it,unless you know how many hours it should take.If it's a flat fee he may just go and butcher everything up, so then you may have to put someone on to watch him.
LBLC_LCO
06-18-2009, 11:33 PM
Hey Fords, we are in the same area...where are you dumping at?
FORDSFUNNYFARM
06-19-2009, 08:10 PM
We don't have any place to dump. We have to leave it for the trash company. That can cost us a fortune at times.
Do you have some place?
SangerLawn
06-19-2009, 10:41 PM
We don't have any place to dump. We have to leave it for the trash company. That can cost us a fortune at times.
Do you have some place?
Look for any place that makes mulch. Almost any large supply company will take your scraps. The place I use makes cheap mulch out of it. As long as there is no plastic or metal with the clippings it is only $10.00 for a tandem trailer load of almost anything I take to them to dump.
LBLC_LCO
06-19-2009, 11:56 PM
We don't have any place to dump. We have to leave it for the trash company. That can cost us a fortune at times.
Do you have some place?
You can check out Missouri Organic, they are up on 40 hwy west of I-70 drive in. I usually go there, it's closer than taking it up to the Courtney Ridge dump on 291. Not sure of prices exactly, but for a full size truck filled to the top of the bed is about $20, trailers vary by size. I get my bulk mulch from them also, about $23/yard for dark brown.
vBulletin® v3.8.6, Copyright ©2000-2012, Jelsoft Enterprises Ltd.