Walbro WYJ metering lever height?

[sanman]

Hi Y'all,

Does anyone know the metering lever height spec for Walbro WYJ carbs? I looked on the Walbro site, and I can only find info on their 'W' tool. I wanted to use the butt end of my caliper, but I can't seem to find the numbers.

Thanks.
Al.

[sanman]

I found the info so I thought I'd let everyone know that the spec is 0.00" on these carbs. It should be set flush with the carb body without the gasket or diagram.

Thanks,
Al.

[sanman]

Just to clarify - it is supposed to be flush with the surrounding, non machined body, but .059" from the machined carb surface.

I hope that's clear enough - it's hard to explain without pics.

Al.

[Breezmister]

Thumbs Up

http://www.walbro.com/default.aspx

[sanman]

Thanks Breezmister!