View Full Version : Little dowel rod that holds elec.clutch in place.

Reynolds & Son Lawn Care
08-28-2009, 08:34 AM
Can you replace that rod without taking the clutch off. I was wondering if the bolt would come out enough so I could pull that rod out and slip a new one in. I am working on a Kaw. engine on a Lazer Z. Thanks

Reynolds & Son Lawn Care
08-28-2009, 11:15 PM
Back to top

08-29-2009, 12:01 AM
There are eight different model Lazer Z's, I'm pretty sure your's isn't EFI so that leaves seven.

Read this (http://www.lawnsite.com/showthread.php?t=144040) and comply so I can see what you are dealing with.

08-29-2009, 12:57 AM
You don't have to fully remove the clutch. Loosen the bolt and try to slid it back to gain clearance. It's tight but it can be done.