PDA

View Full Version : rings for walker kohler20


dobe
08-30-2009, 11:38 PM
Is there a place I can order rings and head gaskets etc for a kohler 20hp motor in a walker mt?
Pretty sure my rings are worned out and i think I have a blown head gasket on one side.

thanks

Restrorob
08-31-2009, 08:07 AM
Either one, Google is your friend.....


http://tewarehouse.com/

http://www.rcpw.com/

dobe
08-31-2009, 01:02 PM
Either one, Google is your friend.....


http://tewarehouse.com/

http://www.rcpw.com/


used google all night but cant seem to find the rings for the ch20 for walker
tewarehouse don't list them for that motor.

the rcpw.com looks like they might have it if I had the part number, and I dont.

Restrorob
08-31-2009, 01:08 PM
ch20 for walker



Forget about the above part, Post the Spec number off this engine.

dobe
08-31-2009, 01:23 PM
Forget about the above part, Post the Spec number off this engine.

must have too much dirt on the motor every sticker i found wont the right one.

where is it normally at on the ch20's? not in the same place as my cv

Restrorob
08-31-2009, 07:47 PM
There should be a white decal on the flywheel cover near the top.....

dobe
08-31-2009, 07:52 PM
There should be a white decal on the flywheel cover near the top.....

im outside now cleaning it off, should know something soon.

dobe
08-31-2009, 08:04 PM
im outside now cleaning it off, should know something soon.

that sticker is not there anymore. its got 17XX hrs on it so who knows.

anything else i can look for?

Restrorob
08-31-2009, 08:08 PM
Dinner bell just rang....Back shortly.....

Restrorob
08-31-2009, 09:13 PM
OK,

If this engine has the drive pulley on the flywheel side with no shaft sticking out of the other side we can assume this isn't a "Basic" engine.

If that's the case there are only seven engines listed for Walker units, All ring part numbers on these engines supersede to new numbers as listed below;

Rings STD; 24 108 22-S
Rings .25 ; 24 108 24-S
Rings .50 ; 24 108 13-S

Complete engine overhaul gasket set; 24 755 107-S

Without a spec number you can only assume these rings will fit your engine, I'm pretty sure the gasket set will without problems.....


Good Luck

dobe
08-31-2009, 10:52 PM
OK,

If this engine has the drive pulley on the flywheel side with no shaft sticking out of the other side we can assume this isn't a "Basic" engine.

If that's the case there are only seven engines listed for Walker units, All ring part numbers on these engines supersede to new numbers as listed below;

Rings STD; 24 108 22-S
Rings .25 ; 24 108 24-S
Rings .50 ; 24 108 13-S

Complete engine overhaul gasket set; 24 755 107-S

Without a spec number you can only assume these rings will fit your engine, I'm pretty sure the gasket set will without problems.....


Good Luck
that sounds right!
thanks im gonna order this stuff now and we will find out
gonna order through jackssmallengines since they are site sponser. all the part numbers found something and they looked to be right on.

hope its just the rings and head gaskets.

thanks a bunch.