Kohler Valve Adjustment

[TRINITY]

I have a Kohler command 25 on a scag that I just purchased used. I am looking for help on the valve adjustment procedure and clearance specs. The Model # is CH25S. Spec# 68579. Serial # is 2730415097. Any help you guys can provide would be much appreciated!

Neal

[Fish]

There is no adjustment on the Command. Is it
running poorly?
Fish

[TRINITY]

When going up a hill it sounds like it is missing or popping a little and is down on power. On the flats it is ok but it kind of sounds like the where the exhaust attaches to the engine there is a leak or a hole in the exhaust somewhere. It ran fine actually until I put some magnum mulching blades on. Coincidence? or do you think those mulch blades are dragging down the power?

Neal

[Fish]

As far as running rough on an incline, it could just
be a layer of water in the bottom of the carb. If
it sounds like you have a gasket leak, you probably
do. Do not run it too long as it will just cost
more money if you wait.
Fish

[TRINITY]

Thanks Fish. I pulled off the muffler tonight and cleaned everything up and put it back together with some high temp silicone. Waiting til tomorrow for the silicone to dry before starting it. I am wondering now if the missing was just from the fuel being too low of fuel in the tank. I will find out tomorrow. Thanks for your help.

Neal