PDA

View Full Version : How do you maintain beveled edges when cutting pavers?


4 seasons lawn&land
10-24-2009, 06:31 PM
One thing I dont get when looking at pictures of jobs with the full width curved is how they sometimes dont show that sharp edge where they were cut. They are fit tight, not curved by opening the gaps yet still maintain the factory beveled edges. Just something id like to understand.

zedosix
10-25-2009, 07:05 PM
We sometimes chip the edges of the radius brick to make it look natural rather than have the sharp edge.

White Gardens
10-25-2009, 07:14 PM
If it's a tumbled paver then I do as stated above, just use a hammer to make it rustic.

If it's a clean paver, no tumble, then you might be able to put a little bevel on the paver with an angle grinder with a diamond blade. Not sure how well that would work though.