1966vette
05-30-2010, 10:36 AM
I'm having problems w/ my 16hP Onan Wheelhorse 616-Z ZTR.
The engine runs fine when cold but shuts off when it gets hot.
I already replaced the coil because it tested defective but the cutoff problem still exists.
I ran 12 volts to the + side of the coil & still no spark. This indicates that the oil pressure sending until is not the problem.
I'm looking for any tips that maybe helpful when I remove the blower housing cover & flywheel.
I'm also in the market for an ignition module for the Onan P216V / 10873A engine.
Thanks!
Andy
The engine runs fine when cold but shuts off when it gets hot.
I already replaced the coil because it tested defective but the cutoff problem still exists.
I ran 12 volts to the + side of the coil & still no spark. This indicates that the oil pressure sending until is not the problem.
I'm looking for any tips that maybe helpful when I remove the blower housing cover & flywheel.
I'm also in the market for an ignition module for the Onan P216V / 10873A engine.
Thanks!
Andy