PDA

View Full Version : Anyone with a Turf Tracer.


exmarkguy123
06-24-2010, 06:27 PM
Hi everyone,
I currently mow with an Exmark Turf Tracer and to be honest i'm not exactly sure what height is optimal for my properties. My question: What height setting should I mow at (what hole should i put the pin).:confused: Thanks!

Hell on Blades
06-24-2010, 08:55 PM
3" fourth hole down -- 1/2" move for each hole.

If you look in your manual, it has the reorder part # for the deck sticker that outlines it.

try 1-553049

albhb3
06-24-2010, 09:15 PM
we run 3 but they are all fert and irr.

exmarkguy123
06-24-2010, 09:21 PM
Great! Thank you so much! I had it on the fourth down, but was a little parenoid that it wasn't optimal.

MileHigh
06-24-2010, 09:27 PM
UMMMMMMMM

It depends on the turf dude.

All my properties are mowed at either at the 3rd or 4th pin sticking up.

Last year one property I mowed on 2, and another on 5.

350yddr
06-24-2010, 09:27 PM
Howdy neighbor,

Yeah, we too run a eXmark TT. This season we're mulching and cutting 3 1/4" (5th hole). Last year we discharged all season at 3", with a power chute. Don't think there is any hard and fast rule about the setup, experiment and go with what looks best. Good luck.

greenstar lawn
06-24-2010, 10:01 PM
I try not to go any lower then the 4th one up but some customers want there grass short which bugs me so i go to a 3 but i have one guy that gets the last one which is a 7

exmarkguy123
06-24-2010, 11:13 PM
Thanks for the info! I really appreciate it.

mowerbrad
06-24-2010, 11:22 PM
You are cutting pretty much the same grass types that I am....I would suggest cutting at around 3"....can't say for sure what hole that would be...but you should be able to figure it out.

MileHigh
06-24-2010, 11:32 PM
my tthp cuts best at 8.5psi in the tires as well as the deck pitch down 1/4 inch in the front.

BigGreen1
06-25-2010, 07:26 PM
Exmark Guy an others,

I purchased a couple sets of thick washers. A few yards are on the 5th hole, a few are on the fourth hole. Most are cut on the fourth hole with a washer under the pin (4 1/2). This is helpful for me because 4th looks scalped, The 5th looks barely cut. Four and a washer is just right.

Tim

brucec32
06-25-2010, 09:39 PM
Measure it yourself and you'll always know which hole is which height