PDA

View Full Version : Help with patio


ALLPro Landscaping
07-19-2010, 09:44 PM
Hello to all, I have a job in progress right now which is a large patio, we are using unilock Camelot pavers, my question whats the easiest way to round corners, I have done a few paver jobs but always just a large square, which this one was supposed to be but now the customer changed his mind. Also since I have rounded corners, would it be a good idea to do the solder coarse first then lay inside pavers Thanks

jake22si
07-20-2010, 07:55 AM
You could use a piece of flexable edging and mark your corner then cut it with your cut off saw. Just make sure to angle in when you cut. It would be faster than laying the soldier course and cutting each individual paver to fit

ALLPro Landscaping
07-20-2010, 11:20 AM
So what ur saying is to lay my interier pavers first mark how i want the remove them to cut then replace them then lay my solder coarse
Posted via Mobile Device

jake22si
07-20-2010, 11:44 AM
I meant lay the pavers and use a gas powered cut off saw to cut them in place being carefull not to move them too much. It's fairly simple. Then if you stepped in the sand, just touch it up for the soldier course.

ALLPro Landscaping
07-20-2010, 05:08 PM
Got it, Thanks alot for your help

jake22si
07-20-2010, 08:52 PM
how did it come out?

ALLPro Landscaping
07-20-2010, 09:17 PM
Let you know on Friday, Laid the base today, I will be laying the pavers on Friday. Ill keep upi posted with some pics