PDA

View Full Version : Crappy Light Brackets for Hustler Super-Z


Farmer Pete
08-21-2010, 11:38 PM
I have a Super-Z with lights. Not sure if anyone else has had this problem, but the right-side bracket snapped in half. It appears to be a bad design in that there is a large cut-out hole in the bracket to house the toggle switch, leaving only a small amount of metal on either side of the hole. The bracket snapped on both sides of the hole (i.e., where the metal was thin). Are there any after-market brackets for the Super-Z? I suppose I could find a shop to fabricate a new bracket for me, but I'd rather not reinvent the wheel if I don't have to. Thanks in advance.

Restrorob
08-22-2010, 12:07 AM
If your smart you'll reinvent the wheel and have them fab up a heavier bracket and be done with it. JMO being a welder/fabricator as well......