PDA

View Full Version : Removing hub assembly


n2ma
09-05-2010, 07:47 PM
I have a 2010 Hustler 60" super Z 31hp kawi.
Once I have the 1 3/4" nut off the hub assembly What is my next step to remove the hub? I have two broken wheel studs. I need helps ASAP!

mowerconsultant
09-07-2010, 05:16 PM
You nee to have a puller for this, do not under any circumstance use heat of any sort, this will destroy the seal in the wheel motor and may cause more damage to the wheel motor.

Pj

n2ma
09-08-2010, 01:35 PM
The hub is fixed now. What a PITA. Trip to autoparts store to rent hub puller.
Then another trip to buy new studs.

mowerconsultant
09-08-2010, 04:32 PM
They are on there really good.
Make sure you torque the nut back to 295 ft. lbs.
If its not torqued right then you will likely cause wheel motor shaft damage and replacing the wheel motor isnít cheap.

Pj