PDA

View Full Version : Snapper Keez Power rake questions


Watkins
04-19-2011, 03:00 AM
I recently puchased a snapper keez ? power rake / thatcher.
I have it in the shop right now and I had to have the rods for the blades made as they were not available anywhere I looked.

After the new blades were installed and a new belt and the rods were added the thatcher was ran for about 2 mins and the bearings that are located within the thatcher failed and the thatcher began to go off balance and vibration occured.

Where in the internet world could I find these bearings ?

I asked him if they were a .056

Watkins
09-14-2012, 08:13 PM
Bump.
Still looking.

Thanks,
I also need new blades, they are flat and about 3 inches or so long by about 1 inch wide.

kawakx125
09-14-2012, 09:17 PM
just measure the bearing and reference it to a chart