PDA

View Full Version : Deck level procedure


UfoPilot
06-08-2011, 03:29 PM
I broke a part on my deck (rear deck hanger bolt) and need to make sure my deck is level after the repair. It's a 61 inch ZJ stander. What is the proper procedure for this? Do I just measure from the ground (flat level surface) to the bottom edge of the deck skirt? Should it be level, or tilted forward or back a little?

WrightCommercial
06-08-2011, 03:35 PM
UfoPilot,

The best is to base it off of the blade tip measurements, you will want it set so the rear tips measure 1/4" higher than the front. The shell can get you in the ballpark but the tips are best to get the correct pitch front to back and level side to side.

Best Regards
Wright Mfg.