PDA

View Full Version : Tecumseh governor setup


samjdmosher
08-09-2011, 05:02 PM
Does anyone out there have a 6-12hp (prefer 9hp) Tecumseh horizontal shaft engine that they can take a picture of the governor and throttle linkage? I just picked one up that someone was "working on" and they had the carb apart and bent the !$%$! out of all the linkage in the process. Now it doesn't make sense how it goes back together because when it's connected, the only way I can figure out how to, it has to over-center the connection to the throttle shaft to get back to idle.

Of course any help is greatly appreciated. The actual engine model is a OHM90-222307B. I scoured the inter-web and found exploded parts diagrams galore but that doesn't help for reassembly after the fact.

dutch1
08-09-2011, 05:21 PM
http://www.allotment.org.uk/assets/rotovator/Tecumseh-Engine-Manual.pdf

Scroll down to around panel 18 or so. They cover some horizontal crankshaft engines. Maybe you'll find something that looks similar to what you have.

samjdmosher
08-09-2011, 05:41 PM
Thank you, that gave me some more clues but it didn't quite fill the gap that I need. Very close diagrams but mine must be just a bit newer.