PDA

View Full Version : Output Shaft thread size of Kawasaki FH430V


whoopassonthebluegrass
03-14-2012, 05:32 PM
Working on a fabrication project and need to determine the thread size of the output shaft. It's a 15hp Kawi.

I tried all my miscellaneous hardware, but couldn't find the right size.

Also, is it reverse threaded?

(EDIT: these are, of course, the internal threads on the output shaft...)

dutch1
03-14-2012, 07:56 PM
If the engine originally had an electric clutch, it's most likely 7/16x20(fine thread) and a right hand thread. If I'm wrong, the big boys will call me on it. I've been away from the larger engines for a couple of years but that is the info that I recall.

piston slapper
03-14-2012, 09:14 PM
Dutch.....sounds good to me...7/16 x 20 is probably right.
Glad to see you woke up .....the smell of biskits and gravee off that B&S fuel pump was almost too much.....put on the feedbag since...good for now....
Posted via Mobile Device

whoopassonthebluegrass
03-14-2012, 09:47 PM
Thanks, and good call. I found a diagram, and you're correct.

dutch1
03-14-2012, 09:57 PM
Glad to help. Even a blind pig finds an ear of corn once in a while!!!!!

larryinalabama
03-14-2012, 10:16 PM
Ask MIKE ...........