PDA

View Full Version : Any tricks to get a little more life out of a battery?


KTM
12-10-2012, 04:09 PM
My batteries are shot in my Case 721B. I have a couple day fence line clearing job coming up, and besides that it will probabley be parked until spring (unless we get good snow) I know i am being cheap but i would like to put off buying new ones until spring when I start buildng again ($340 for new ones) any tricks? had a old concrete guy tell me to "shock them" out of the machine in a safe area, but would like more opinions.

Kepple Services
12-10-2012, 05:32 PM
Get a battery tender.. and leave them plugged in for the winter, it will condition the batteries as well as keep them charged.

bobcat_ron
12-10-2012, 07:37 PM
My dad used to put a rubber liner under the battery and insulate the holder from the machine. It might be an old wives tale, but he would replace a battery once every 5 years in his old excavators, so there might be some truth in that.
Posted via Mobile Device

patrick6411
12-10-2012, 08:19 PM
My uncle has three golf carts. He just recently purchased some battery conditioner for one of his carts. It brought the batteries back to life in that cart. The batteries were not totally dead but would not hold a charge very long. You might try calling a golf cart place and asking them about this.

Another thing he does is uses a battery conditioner that is solar powered. One of his carts are 5 years old and has never had new batteries replaced.

Impact-Vector
12-10-2012, 09:13 PM
+1 for battery tender. Worth every cent!

Bigred350
12-11-2012, 06:24 PM
I have heard don't lay them on a concrete floor. Put a wood block under them or up on a shelf. Don't know why but "that's what they say".


Also be carful with battery tenders. They can make batteries get to hot and catch on fire. So just be smart about what they are sitting next to.

KTM
12-11-2012, 06:59 PM
last night i put epsom salt in them and charged them and they fired it right up this morning. Yesterday they would not take a charge:dancing:.

AEL
12-11-2012, 08:19 PM
Why not just replace them? Running shot batteries is hard on alternator, starter etc. better to be able to start the machine in mid winter then be screwing around changing batteries in the cold.
Posted via Mobile Device

KTM
12-11-2012, 10:08 PM
Why not just replace them? Running shot batteries is hard on alternator, starter etc. better to be able to start the machine in mid winter then be screwing around changing batteries in the cold.
Posted via Mobile Device

Besides a few hours today and a couple more tomorrow the machine will most lickely be parked until late March-April, unless we get big snowfall. I would rather buy fresh batteries then rather then have them sit through 3 months of winter. If i need it again I will buy new ones. then I will use a battery tender next time it sits for long periods.

dieselss
12-13-2012, 09:22 PM
Another trick. Install a batt disconnect switch
Posted via Mobile Device

norsky
12-14-2012, 10:39 PM
I have heard don't lay them on a concrete floor. Put a wood block under them or up on a shelf. Don't know why but "that's what they say". this use to be true years and years ago, the battery would discharge through the case to the concrete. but the battery cases are built of material that will not allow that any more.


Also be carful with battery tenders. They can make batteries get to hot and catch on fire. So just be smart about what they are sitting next to. this use to be true years and years ago, the battery would discharge through the case to the concrete. but the battery cases are built of material that will not allow that any more.