PDA

View Full Version : Exmark Turf Tracer 48''


LawnMan19
12-29-2012, 07:04 PM
Hey, I need some advice could anyone tell me how to disengage the hydros on a Turf Tracer to be able to move it without running the engine or damaging the hydros.
Thanks

LawnMan19
12-29-2012, 08:49 PM
Anyone????

RodneyK
12-29-2012, 09:00 PM
I think there is a nut on the hydros to turn that releases them.

LawnMan19
12-29-2012, 09:01 PM
I think there is a nut on the hydros to turn that releases them.

Thanks a lot man.

sjessen
12-29-2012, 09:31 PM
Yes, as stated above, each pump has a dump valve which looks like a nut on a bolt on the back of the bump. Loosening that will relieve the pressure. When retightening be careful to avoiding getting them too tight.

LawnMan19
12-29-2012, 09:41 PM
Yes, as stated above, each pump has a dump valve which looks like a nut on a bolt on the back of the bump. Loosening that will relieve the pressure. When retightening be careful to avoiding getting them too tight.

Thank you very much, I know their had to be something but had no clue. I appreciate it a lot man

sjessen
12-29-2012, 09:42 PM
You are quite welcome!! Glad to be of some help.

LawnMan19
12-29-2012, 09:48 PM
You are quite welcome!! Glad to be of some help.

You're a great help, now I don't need to spend a whole day trying to figure it out.

RodneyK
12-29-2012, 10:02 PM
http://www.exmark.com/pdfs/4500-358.pdf

Page 18, drive wheel release valves upper right hand column.

LawnMan19
12-29-2012, 10:05 PM
http://www.exmark.com/pdfs/4500-358.pdf

Page 18, drive wheel release valves upper right hand column.

Damn your good man.
Thanks