PDA

View Full Version : someone please explain


hoeman376
01-01-2013, 03:22 PM
http://www.ebay.com/itm/Continuous-Excavator-600-to-900-Tons-and-Hour-Mining-FLSMIDTH-Rahco-CME-12-/230903793487?pt=LH_DefaultDomain_0&hash=item35c2f0474f

Scag48
01-01-2013, 08:48 PM
Says it's for open face coal mining however I'd have to argue that. You'd have to wait for trucks just like a front shovel, so unless there was some sort of walking conveyor/stockpile pit that followed the machine around that conveyor loads the trucks, I don't see how it would be more efficient than a front shovel. I could see this as being more of a shaft mining machine but it's pretty large for that. Definitely a unique piece of gear.

alco
01-02-2013, 02:20 AM
That's a Rahco surface miner. Basically, it's just like an asphalt milling machine, and pulverizes the material it's being used on, as well as loads it out at the same time. Typically, they are used for thin seams of material, or large flat lying deposits.

It has to stop periodically to exchange trucks under the conveyor, but only really has to pause for a couple seconds while the next truck spots in. In a thin seam, a shovel will have to move too much while loading, and can't easily shave off a thin layer like this machine can.

While the machines are a bit different, here's a video of a surface miner being used on iron ore in Australia. Same general concept, but a slightly different machine design, as the Rahco uses a front mounted cutting drum.

http://www.youtube.com/watch?v=T_o1KuG3Y8A

One really nice advantage of a surface miner, is that you don't need a primary crusher. These don't need blasting either, though they aren't made for extremely hard rock.

Basically, they have some applications where they excel, and others where they are not practical.