PDA

View Full Version : String trimming - two questions


BigDave
05-14-2003, 07:48 AM
1. I use my Homelite string trimmer for edging. I notice that it sure brings up a lot of dirt and blows it into oblivion. Should I be concerned about this "soil removal" and perhaps buy a dedicated edger, or am I being way too cautious?

2. What are the pros and cons of thicker and thinner string? I'm assuming that thicker string such as .095 inch will break less easily - but then why would someone buy thinner string such as .080 inch?

Thanks all!

stslawncare
05-14-2003, 09:29 AM
i believe the thickness of string goes with the type of material u are cutting. if you are using the trimmer for a lot of edgine u want thicker, if you are using it for long thick overgrown grass you want thicker, but if you are using it for maintained grass trimming you want thinner as it will give you a better cut.

KerryB
05-14-2003, 01:45 PM
I use .105 string. Works better for me.
As for edging I only use my trimmer to freshen up an edge. I use a Stihl edger to do my edging.

BigDave
05-15-2003, 09:02 AM
Thanks! Good explanations on string thickness - it makes sense.

Any thoughts on my first question? Is using a string trimmer for edging unhealthy because it blows away too much soil?

stslawncare
05-15-2003, 01:04 PM
if done properly no harm at all.

Doogiegh
05-16-2003, 12:03 AM
Before you buy a whole roll of .095, check to see if your trimmer can use it. Some trimmers feed holes are drilled only so big and only allow .080..

Gary

TurfGuyTX
05-18-2003, 10:41 PM
Once you have an edge established, there should be only minimal dirt removal. You may be trying to edge too deeply.

stevieraysod
05-19-2003, 03:38 PM
I've read that .95 line is a little weighty for curved shaft trimmers and is hard on the driveshaft. Best to stick with .80 in curved shaft models. .95 is OK in straight shaft units.

BigDave
05-21-2003, 07:57 AM
Thanks all! It makes a lot of sense to establish and maintain an edge to minimize soil removal. And, I did notice last night that my .95" string had a harder time slicing through thick grass than the .80" did -- so will plan to go back to .80" when I'm done with this spool (if the ol' Homelite lasts that long).