PDA

View Full Version : Oil change, greasing....


lildog132
06-25-2003, 08:16 PM
Im an idiot... I don't know how to change my oil on my 36" scag WB. I bought it about 2 weeks ago used from some guy and im pretty new at commerical stuff. Well i was just wondering how to release the oil??? Its on the bottom somewhere right? I know you guys are probally laughing your A$$es off right now.. sorry, i just can't find it. and also, how many squirts do you pump into each grease spot? please help me out

bob
06-25-2003, 08:49 PM
Call your local Scag dealer.

LAWNGODFATHER
06-25-2003, 10:15 PM
Originally posted by bob
Call your local Scag dealer. Also get a manual...

rvsuper
06-25-2003, 10:46 PM
Pump the grease gun until the grease just starts coming out.

Rustic Goat
06-26-2003, 12:04 AM
Is engine a 15HP Kohler?
Know what the oil filter is/looks like?
Looking from back (where you'd normally stand when operating the mower) towards front, oil filter is located (basically) near left rear corner of engine. Continue up the left side of engine, at a level just below the oil filter, three inches at most.
You'll see a square headed bolt, on the side but very near the bottom of engine. It's also just about an inch above the surface of the deck.
Just below square headed bolt is about a 2" round hole in the deck.
Remove bolt, drain oil.
There is also a similar bolt (just smaller) below the oil filter, remove this bolt before removing filter, it drains oil out of filter.l