View Full Version : craftsman bagger fits my Exmark

11-02-2003, 07:06 PM
Hate to even admit it but my Exmark 23/60 accepts the bagger off my old crapsman didnt even need to drill it out. All I had to do was add a 3 ft pc of pipe where it came up short. Works great too. as long as the leaves are a little dry it sucks'me right up. Run through the thick ones first with the Ransome with the gators and follow with the lazer and Whola clean as a whistle, This is gonna be fun fron now on

11-02-2003, 07:41 PM
Where did the three foot piece of pipe go?This statement has the makings of an off-handed joke, but I'm curious to know how the three foot pipe fits in. Damn, I did it again!

John Gamba
11-02-2003, 07:45 PM

11-02-2003, 08:28 PM
John go ahead and laugh!
the freakin thing works, you should have seen the grin on my face.
A ultra vac would be nice but Iam on a budget. Well maybe just a cheap SOB
The only bad thing is it doesnt have 3 bags

the 3 foot pc of pipe is the same kind of pipe they use on the ferris bagger systems UDF vacum tube From Grand Rapids Rubber
it just fits over the crapsman bagging tube in between there is a gap should I take a picture.

John tell me where I can get a peco blower?

John Gamba
11-03-2003, 06:49 AM
I'm not laughing at you, I just think it's cute :D . I've never owned a peco?

11-03-2003, 11:02 AM
Originally posted by John Gamba
I'm not laughing at you, I just think it's cute ?
John No John, cute would be, The bagger on the Crapsman.

John Gamba
11-03-2003, 12:30 PM
:laugh: :laugh: