18 HP Kohler on Sears mower, solinold clicking

[GTA]

That's right. Has a hot battery, everything is tight, starter is good. When the key is turnered nothing but rapid clicking comes from the solinold. Whats wrong?

By the way it's a 917 model with the 18 horse twin Kohler Magnum engine.
Thanks

GT

[xcopterdoc]

have the battery load tested. Just because it has 12 volts that doesnt mean it will handle the load. Load test battery, clean and tighten all connections on battery and starter. try it again. If it still clicks rapidly, remove the starter and take it to a starter repair shop and let them have a look at it.

[grass_cuttin_fool]

Check the battery ground where it makes contact with the frame

[Green Care]

Also had a kolher that did that on a giant vac the ground was not good the motor broke lose so I went and bought another cable to ground in another place also.

[mudpie]

usually if it`s just clicking it is a bad solinold. dirty battery cables. or bad ground on solinold.

[taylob]

You might want to check the voltage to the flag terminal on the starter solenoid. It should be no less than 7.5 volts. Check this both with key on and cranking to see if there is too much load. Load testing the battery is good. Need to make sure you have good voltage first. It could be a sears issue with a relay. They use them instead of fuses now.

[BODIDDLY]

im having the same problem.bought new key switch and starter.should i buy a relay kit..