exmark tracking

[loud_mouth22]

any good ways to track theese hydros mine pulls to the left and my reverse on one wheel is faster than the other is this a simple adjustment thanx:confused:

[Mikes Machines]

I am not that familiar with Exmarks so I cant tell you exactly how to adjust it. Most hydro drive machines have a provision for adjustment forward and reverse. The idea is that you limit how far the shaft going into the pump turns when you squeeze or release the hand controls. With the engine off have someone move the controls and watch the linkage move. You should be able to see an adjuster close to the pump. You always slow down the fast side because you cant speed up the slow side.

[sawman65]

do you have your owners book? you need it, there is no simple way to do this

[loud_mouth22]

dont have owners book and am new to this the mower has 1020 hours and is a 60 im thinking about getting a wright or great dane any advice

[wireman36]

The Exmarks have a white star adjustment wheel located under
the seat between the pumps and can be rotated a 1/4 turn and then tested. My manual said that some of the older models
(goes by manuf. number) cannot be adusted and that you would
have to compensate as needed.

[dan5427]

dont buy a wright or a great dane, they are junk!! Buy a new exmark they are great machines.

[loud_mouth22]

this is a walk behind and why do the gds and wright suck

[jsr2741]

I just did mine about 2 weeks ago. I had to adjust the linkage's after I couldn't correct it by adjusting the tracking anymore.

[Mikes Machines]

Originally posted by dan5427
dont buy a wright or a great dane, they are junk!! Buy a new exmark they are great machines.


I have never heard bad about a Wright. What kind of problems do they have? I was sort of considering one.