Walker Hydro Part Numbers

[fbcoop]

I need to order a new hydro for the right side drive on my walker. The Walker book tells me the part number is a 5025. It is the CCW rotation and the Eaton deisgnation is 700-032. In the J. Thomas catalog they list the right side as 700-031 part # 5026.
For the Walker mechanics out there what's the right one? J. Thomas has the best price $449 for the replacement but I don't want to order it and find out the were looking at right and left from different perspectives. (looking at the machine as opposed to sitting on it)

Thanks,

Coop

[fixer67]

Left and right are as seen from the drivers seat. Check the pump face right below the pulley. It is stamped into the case CW or CCW. I can not remember off hand but the Eaton number maybe there as well. Tell me a little about the problem you may not need a pump. The relief can stick in and cause it not to pull, the bearing and input shaft can be replaced and when was the last time you changed the fuild and what type did yopu put back in? Pumps do go bad and I have replace more than a few but on the other hand I have saved a few as well. Good luck.

[lucforce]

I know that this is an old thread, but I am a new member and I have been searching through a few topics and wanted to put this in for other's future searches - No matter which pump rotation you receive, you received the correct pump. You can "reclock" a cw pump to be a ccw pump and vice versa.
1. WITHOUT removing the pump halves, remove the four bolts that hold the pump together.
2. While holding pump together on bench, rotate one pump halve 180 degrees.
3. Reinstall and torque four bolts to spec.

Normally this is not an issue - But, if you get sent the "wrong" pump or if the warehouse has six cw and zero ccw pumps, you are still in business.